Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Troubleshooting Desktop Motherboards, Graphics Cards, and PC Peripherals
Register FAQ Calendar Search Today's Posts Mark Forums Read

Thread Tools Display Modes
Old 01-21-2022, 09:35 PM   #1
Join Date: Sep 2021
City & State: ORANGE/NSW
My Country: australia
I'm a: Knowledge Seeker
Posts: 24
Default rx580 not detected/ no display/ messing with primary card

Hi everyone

I've got a bit of a funny one, I've got an rx580 that is not detected/ wont display. It had all of the voltages needed on the core, memory, memory controller, 1.8 and 1.8 enable but the core wasn't getting warm. I found a 1k ohm resistor that was maybe missing from the pex reset A11 pin (R120 it didn't look like it was originally there but is on the board viewer). Now my core is starting to get warm but its still not detected. I have found that I don't have a 3.3V VDDC_VDDCI_PWROK signal because I don't have a 3.3V VDDC_PWR_GOOD signal to the nc7sz08p5x U1000 chip, I do have 3.3v PERSTB_BUF. I have tried putting a 5k ohm resistor from 3.3V to the power good pin but I still get no output for power ok. Is there anything else I can check? It also stops the fan from spinning on my main card if I run the faulty card as a second card. I also get no fan spin on the faulty card on windows but the fans initially spin on my HiveOS Linux machine. I do have a couple of cards here that i can check voltages and stuff on.

Thanks, Kurt
woody-009 is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump Technical Forums 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 07:28 PM.
Did you find this forum helpful?