Announcement

Collapse
No announcement yet.

Asus MK241H no power

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #61
    Re: Asus MK241H no power

    Thank you very much. I will look into it.
    Yesteday I have sent a private message to the person who gave me the resistor values, but I don't have much hope that he will answer.
    Which transistor is the Q101? Which one did you buy?
    Last edited by tibimakai; 01-13-2013, 08:10 PM.

    Comment


      #62
      Re: Asus MK241H no power

      Never mind, the transistor I have replaced already a while back.

      Comment


        #63
        Re: Asus MK241H no power

        CORRECTION! In the previous post, I said that R172 was .01 ohm. I should have said 0.1 ohms - still 2 watt. BTW the SMT resistors are 805.

        Comment


          #64
          Re: Asus MK241H no power

          Ignore last post - brain fart. Original post was correct. For Q101 I used an STF18NM60N.

          Comment


            #65
            Re: Asus MK241H no power

            I have ordered 0.1 Ohm/2W resistor.
            I'm waiting for the parts to arrive.
            I don't know how come I haven't checked this resistor, it's so obvious that is open, I can actually see a piece blown from it.
            I was concentrating so much on the SMD parts, that I have forgot to actually look on the other side of the board for bad through hole components.

            Comment


              #66
              Re: Asus MK241H no power

              I have replaced the mentioned components and there is no change.
              The only voltage I'm getting is the 166V, nothing else.
              The TEA chip is not getting the right Vcc(which I don't know how much it should be), it's only getting 1.8V. At the pin 8 I have 141V.

              Comment


                #67
                Re: Asus MK241H no power

                I have looked at the TEA pdf and there it is mentioned that the Vcc is getting from the transformer after the PS is started.
                So this IC won't start only after the PS is started.
                I must have another problem that is causing to not start.
                At the output connector that goes to the mainboard, I'm not getting almost anything. On some of the pins I'm getting less then 0.5V.
                Should I have standby voltage? No light turns on, when plugged in.

                Comment


                  #68
                  Re: Asus MK241H no power

                  Nobody can help?

                  Comment


                    #69
                    Re: Asus MK241H no power

                    Nobody can explain to me what should be happening with this PS to be able to start?
                    It should have a standby voltage? On the output connector toward the mainboard, nothing is printed on the board.

                    Comment


                      #70
                      Re: Asus MK241H no power

                      I have just gave up and purchased a new board from Ebay ($49.90), put it in and it's working great.
                      The only check I have done is to make sure that we had the right resistors and we did.
                      It's a nice monitor, with webcam, speaker, HDMI input.

                      Comment


                        #71
                        Re: Asus MK241H no power

                        Hi, I have problem with the same asus display. No power, no stby, no led. I found broken D115 Schootky Diode mbrf20200ct. Replace it and now display works!

                        Sorry for my poor english.

                        Comment


                          #72
                          Re: Asus MK241H no power

                          I have removed that diode and measured it and it conducts in one way and doesn't conduct the other way. That is good? It shouldn't conduct a bit the other way?

                          Comment


                            #73
                            Re: Asus MK241H no power

                            Originally posted by stodek View Post
                            Hi, I have problem with the same asus display. No power, no stby, no led. I found broken D115 Schootky Diode mbrf20200ct. Replace it and now display works!

                            Sorry for my poor english.
                            you saved my head from burning

                            Comment

                            Working...
                            X