That is a much better resistance than before. If the other side of L6995 is also a high reading, then proceed to solder back L6995 so that it can perform its job.
The voltage output of L6995 should be ~3v42 if all is well on this rail.
I would buy a Costco lot of U7941 devices from Aliexpress. Do ask if they are valid for macbook repairs but believe this is a fixed function device that should just operate as expected upon soldering. Silego has many programmable devices and you need special tools and IP to configure them otherwise.
Remove all power and check the resistance to ground of the 3 x outputs of this device (pin 4, 3 and 8).
Comment