I am using this reworking station for some time but not too extensive.It is doing ok , but sometimes it takes very long to get a part of the board.
Now I did a temp measuring and on the highest setting = 480 C my temp meter with the K-type element shows 398 C as highest.
Yes , it is not that accurate.
Is there a way to up the maximum temp a bit more , or is the 398 C a way , to let the heat element have a longer life ??
Any thoughts are welcome
Now I did a temp measuring and on the highest setting = 480 C my temp meter with the K-type element shows 398 C as highest.
Yes , it is not that accurate.
Is there a way to up the maximum temp a bit more , or is the 398 C a way , to let the heat element have a longer life ??
Any thoughts are welcome
Comment