remove the bios chip before reading from the motherboard and solder on the programmer if you do not have an adapter ..maybe the bios chip is defective ..
Hi everyone,
Thank you first for all the informations and services offered on the site.
I have to unlock a HP 820 G1 (bios locked). It would seem, to make a correct bios dump, that it is necessary, on this model, either desolder the eeprom, or solder wires to it (and dump for only the eeprom, not eeprom + EC). Am I right ? I do not know these technics: would you have a solution that would only require a simple clip? Do you need to use any particular software and, if so, which one ?
Thanks for rour reply and best regards.
Hi everyone,
Thank you first for all the informations and services offered on the site.
I have to unlock a HP 820 G1 (bios locked). It would seem, to make a correct bios dump, that it is necessary, on this model, either desolder the eeprom, or solder wires to it (and dump for only the eeprom, not eeprom + EC). Am I right ? I do not know these technics: would you have a solution that would only require a simple clip? Do you need to use any particular software and, if so, which one ?
Thanks for rour reply and best regards.
Yes, of course. But I want to know if, for unlocking a bios password, I must make dump(s) of only the eeprom or eeprom AND EC ? And about making the bios dump, must I desoldier it (never do it before) or can I use a clip + ch341A + flashrom or ch341a software or another programmer software (which one in this case) ?
Thanks for your reply and best regards
Yes, of course. But I want to know if, for unlocking a bios password, I must make dump(s) of only the eeprom or eeprom AND EC ? And about making the bios dump, must I desoldier it (never do it before) or can I use a clip + ch341A + flashrom or ch341a software or another programmer software (which one in this case) ?
Thanks for your reply and best regards
you only need to remove the contents from the bios chip, it is good to remove the chip from the motherboard, and solder it on the programmer if you have ch341A,
and you do not have an adapter for bios chips ..
you can soder wires between the programmer and the chip bios on the motherboard,
if you can't remove it..do not use the clip because you will have errors..
don't forget to make a bios copy before writing the bios chip..if you have CH341A use one of these two programs ..
Hi, I have 820 G1 [2pcs] laptops. Both laptops had delay display problem due to bad me region. I flashed bios with clean me . Now display comes in 2-3 seconds. But shows error
Warning Machine is not in committed State.
Can anybody help me to get rid of this error ??
Thanks in Advance
Hi, I have 820 G1 [2pcs] laptops. Both laptops had delay display problem due to bad me region. I flashed bios with clean me . Now display comes in 2-3 seconds. But shows error
Warning Machine is not in committed State.
Can anybody help me to get rid of this error ??
Thanks in Advance
---------------------------------------------------------------------------------------------------------------------------------------------------------- All donations to Badcaps are welcome. Become a Badcaps supporter >>>>>click on this link to donate <<<<< Thanks to all supporters. ----------------------------------------------------------------------------------------------------------------------------------------------------------
Comment