hi to all members.after change the blown transistors A1294 and the driver trans 4793 and 1837 i have dc 30v on the repaired chanel when start the amp and drops slow to near zero after 10-15 min.change all the smd resistors before the driver trans was out of specs.and i give 1khz signal but nothing happen on front leds only the sig led is on and goes of when the dc on the output drops.emiter res is all ok checked.where i have to check? any advice it would be very helpful.
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
qsc gx3
Collapse
X
Comment