I found used PSU AcBel PC6001 ~250W from IBM thinkcenter Core2Duo system. Almost every output rail caps were bulged except 12V rail single cap. caps were Ltec
12V - 1200uF 16V
5V - 1000uF 10V before coil 1000uF 10V after coil
3.3V - 1000uF 10V before coil 1000uF 10V after coil
5Vsb - 1000uF 10V before coil, 470uF 16V after coil
Since I have no access to buying new branded caps, I'm going to replace caps with used caps I pulled from dead PSUs and Motherboards.
I need cap experts ideas about it.
This PSU will be use for light load. Mini-Itx J1800. total power consumption not more than 50W.
I have following capacitors that fits: (Order by age.)
Teapo 1000uF 10V, 3300uF 16V & 10V - most recent
Ost RLP 1000uF 10V, RLS 2200uF 10V, RLX 2200uF 16V, RLX 3300uF 16V
Nippon chemi con KZG 1500, 2200, 3300 6.3v, KY 1000uF 16v, 25V
Rubycon MBZ 2200uF 6.3V
what you think? should I take teapo or better brand ?
12V - 1200uF 16V
5V - 1000uF 10V before coil 1000uF 10V after coil
3.3V - 1000uF 10V before coil 1000uF 10V after coil
5Vsb - 1000uF 10V before coil, 470uF 16V after coil
Since I have no access to buying new branded caps, I'm going to replace caps with used caps I pulled from dead PSUs and Motherboards.
I need cap experts ideas about it.
This PSU will be use for light load. Mini-Itx J1800. total power consumption not more than 50W.
I have following capacitors that fits: (Order by age.)
Teapo 1000uF 10V, 3300uF 16V & 10V - most recent
Ost RLP 1000uF 10V, RLS 2200uF 10V, RLX 2200uF 16V, RLX 3300uF 16V
Nippon chemi con KZG 1500, 2200, 3300 6.3v, KY 1000uF 16v, 25V
Rubycon MBZ 2200uF 6.3V
what you think? should I take teapo or better brand ?
Comment