The ene kbc was shorted, so i replaced it with a new one and programmed it as well with Rt809F. unit still has no 3.3v
I have tried the following:
01. Replaced another new kbc and programmed-still same
02. Replaced Pu200 with TPS 51125-still same
03.Replaced Pu100(ISL88731)-still same.
04. There is no short on 3v and 5v coils(PL200 & PL201)
05.Tried flashing both Eprom's-still same.
I have noticed one thing which has left me puzzled--If i connect pin16 of Kbd Connector(which is connected to pin 42 of KBC) to Ground-all voltaged appears on the board-3.3v at battery terminals and power switch. Mb wont turn on simply coz connecting pin 42 of kbc to Gnd means KBC is in programming mode.
So whats wrong???
Please advise friends as i have run out of ideas.
I m sure that tps51125 does not replace RT8205L in your case Because I have already tried it in this model, but i don't know why
Comment