My question is about substituting a Sanyo SEPC 820/4.0 for a bulged KZG 820/6.3.
If this is not appropriate, it is better recommended to use 1000/6.3 instead?
These are field caps, not located in the VRM.
The board is a Dell 775 BTX from a Dimension 5150.
I took a gamble and replaced the three bulgers, but the board is still living in Beeping Hell.
This was a basket case dumped in my lap.
It came without CPU, so I bought a $20 P4/650 off eBay.
If this is not appropriate, it is better recommended to use 1000/6.3 instead?
These are field caps, not located in the VRM.
The board is a Dell 775 BTX from a Dimension 5150.
I took a gamble and replaced the three bulgers, but the board is still living in Beeping Hell.
This was a basket case dumped in my lap.
It came without CPU, so I bought a $20 P4/650 off eBay.
Comment