This set has a 0500-0407-0680 (DPS-280LP) power supply. Through troubleshooting I found Q901 N-ch Power FET shorted which I replaced, along with R908 an SMD resistor open. The value of this resistor was blown off the top so I have no idea of the value. I have searched for a schematic for this supply to no avail. Does anyone have a schematic from which they could give me the value of this resistor(R908). Thanks much for any help. JMHammond
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
Vizio VO47LFHDTV30A Dead Set
Collapse
X
-
Re: Vizio VO47LFHDTV30A Dead Set
Q901 is for the STBY Power supply so it means that the SMD SMPS IC is more likely to be damaged also which you should replace otherwise you new MOSFET will be damaged. There may a fusible fuse that feed the B+ to this STBY section.
Can we see good clear pictures of you board both sides (the whole board, and also in 1/4 section so I can easily see the traces to trace out the connection)
The resistor that burn up may be for the Gated drive R/D network, also need to find out of there is <1 Ohm resistor connected to the Source pin that needs to be check to find out if it also went open circuit when the MOSFET shorted out.
This is the same board as yours?
http://www.shopjimmy.com/vizio-0500-...wer-supply.htmNever stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
First off apologize for thread highjacking, but we may have the same problem.
I tested all the pins to the bottom right of the board and no voltage?. Weird, and I made sure my multimeter was O.K. by testing other devices, even the wall outlet haha. Would this be a bad voltage regulator?
Quick history on the board, previous owner which is an old friend of mine replaced two resistors
- R901
- R601
I'm not sure when to the time it broke on me, probably a few months? But my girly and I was just watching the TV and it shut off, and i get no power led's nothing its completely dead. I have fixed some TV's in the past that just had the obvious blown caps. Here is some pics of the boards, which are exactly what you posted above.
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
@ej, it will be better for you to start another thread so it will be confusing when two people are asking the questions.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
It would seem I have a similar problem with this PS board. I have voltage all across the board till I get to the secondary section, then I have nothing. I'm unsure of whether I just lost the 5v stby and the rest is fine, or if there are larger scale issues. I'm not sure where to begin from there. I have some electronics knowledge, I repair radio gear form time to time, but this is beyond what I'm used to working with. Hopefully someone can give me a hand getting this set fixed, Thanks
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
@tinkerer: Same exact model power supply and TV model? It may be better to start a new thread with make and model.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
Currently working on this board. What are the ohms of R901/601? They are the same. From looking at the colors it is Red Red Silver Gold Silver. When I try to look this up I can't find a resistor with the third strip as Silver. I can see that one of the resistor is damaged. There is no reading across it.
Comment
-
Re: Vizio VO47LFHDTV30A Dead Set
Originally posted by trixter View PostCurrently working on this board. What are the ohms of R901/601? They are the same. From looking at the colors it is Red Red Silver Gold Silver. When I try to look this up I can't find a resistor with the third strip as Silver. I can see that one of the resistor is damaged. There is no reading across it.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
Comment
Comment