I have this laptop who had some short in power lines and bios failure.I repaired short and i found some bios dump on the internet..and laptop would start..but with problems...the bios logo would turn on after 15 seconds or more...and it wouldnt install graphic card drivers (not recognised) so in bios i had only basic display adapter.
So i used Intel ME/TXE Injector to clean ME region. i have to mention that this is my first time to clean ME region. So i picked first Suitable ME version that program displayed (but not the same number as my BIOS ME version).
Now everything is ok, bios logo is up in 2 seconds, graphic card drivers installed...but one problem ...Intel Management Engine Interface is showing mark ! with error Code 10. i tried to install few other drivers...but after 30 seconds it goes back to error code 10. And i have to mention that i didnt have this error on not cleaned BIOS (that one with problems above).
So, what am i doing wrong? Did i have to use ME version with exact number as BIOS (even though the program is saying that others are suitable also) Or something else?
thx
So i used Intel ME/TXE Injector to clean ME region. i have to mention that this is my first time to clean ME region. So i picked first Suitable ME version that program displayed (but not the same number as my BIOS ME version).
Now everything is ok, bios logo is up in 2 seconds, graphic card drivers installed...but one problem ...Intel Management Engine Interface is showing mark ! with error Code 10. i tried to install few other drivers...but after 30 seconds it goes back to error code 10. And i have to mention that i didnt have this error on not cleaned BIOS (that one with problems above).
So, what am i doing wrong? Did i have to use ME version with exact number as BIOS (even though the program is saying that others are suitable also) Or something else?
thx
Comment