The main problem is that the plate is very crooked and I cannot understand why.
It also displays an error when powered up:
Initial zero point over ±10% (take 10% as the benchmark)
Check and remove any objectfrom weighing pan or malfunction of LOAD CELL
I believe this is caused by the crooked plate.
Some pictures from the insides as attachments.
Picture 4: Is that screw supposed to be there? I think that has something to do with the problem. The mechanism is bolted in at the other end.
I would be glad to receive any ideas. The model is Jadever LPWN-1530
It also displays an error when powered up:
Initial zero point over ±10% (take 10% as the benchmark)
Check and remove any objectfrom weighing pan or malfunction of LOAD CELL
I believe this is caused by the crooked plate.
Some pictures from the insides as attachments.
Picture 4: Is that screw supposed to be there? I think that has something to do with the problem. The mechanism is bolted in at the other end.
I would be glad to receive any ideas. The model is Jadever LPWN-1530
Comment