Badcaps.net Forum
Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Troubleshooting Laptops, Tablets, and Mobile Devices
Register FAQ Calendar Search Today's Posts Mark Forums Read

 
Thread Tools Display Modes
Old 12-27-2019, 11:40 AM   #21
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by jasko_jacker View Post
I soldered a new dual mosfet , changed the burnt coil and replace the inductor. Now at the end of PL901 there is 1.4V . all that remains is to replace the capacitor (19V to GND) with an appropriate value, which value do you recommend?
No problem with down side. My problem with top side.
1.jpg
this ? probably wrong or my dead resistor give my technician wrong value?
chorumluum is offline   Reply With Quote
Old 12-27-2019, 02:52 PM   #22
jasko_jacker
Badcaps Veteran
 
Join Date: Oct 2014
City & State: roma
My Country: italy
Line Voltage: 220 V
I'm a: Knowledge Seeker
Posts: 934
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by chorumluum View Post
No problem with down side. My problem with top side.
Attachment 204729
this ? probably wrong or my dead resistor give my technician wrong value?
Pl500 0 Ohm is correct (Pl is not measured in Ohm but in Henry).
But what's your problem ? missing ddr4 voltage ?
To understand this part of the circuit you must find the datasheet of the A0S70S controller and you must find the missing signals with the motherboard powered. A damaged resistance hardly changes its value is more likely to be shorted or non-conductive.
jasko_jacker is offline   Reply With Quote
Old 12-27-2019, 03:05 PM   #23
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by jasko_jacker View Post
Pl500 0 Ohm is correct (Pl is not measured in Ohm but in Henry).
But what's your problem ? missing ddr4 voltage ?
To understand this part of the circuit you must find the datasheet of the A0S70S controller and you must find the missing signals with the motherboard powered. A damaged resistance hardly changes its value is more likely to be shorted or non-conductive.
No when i push the open button the light open but no fan action or screen or beep. Shoutdown automaticly.
chorumluum is offline   Reply With Quote
Old 12-28-2019, 04:25 AM   #24
jasko_jacker
Badcaps Veteran
 
Join Date: Oct 2014
City & State: roma
My Country: italy
Line Voltage: 220 V
I'm a: Knowledge Seeker
Posts: 934
Default Re: Dell INSPIRION 15 7567 BSOD

If you connect the adapter and you don't push the power button the battery led is on ?
Have you try to reprogramm bios or EC ?
jasko_jacker is offline   Reply With Quote
Old 12-28-2019, 12:07 PM   #25
jasko_jacker
Badcaps Veteran
 
Join Date: Oct 2014
City & State: roma
My Country: italy
Line Voltage: 220 V
I'm a: Knowledge Seeker
Posts: 934
Default Re: Dell INSPIRION 15 7567 BSOD

SOLVED
Having no information on the components, I replaced the damaged capacitor on the PQ900 -> DRAIN-> GND with
a value of 10 mF. After installing win10 the video card and its memory are detected correctly. The ACPI BSOD message is resolved without reprogramming the bios
Attached Images
File Type: jpg LA_D993P_GPU_VRAM_SOLVED_1.jpg (712.5 KB, 116 views)
File Type: jpg LA_D993P_GPU_VRAM_SOLVED_2.jpg (769.8 KB, 68 views)
jasko_jacker is offline   Reply With Quote
Old 01-01-2020, 02:35 PM   #26
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

IMG_20200101_233325.jpg
i talked with my techician and he told me wrong resistor actually he need to this arrow resistor can you help me? And they type like 1206?
Quote:
Originally Posted by jasko_jacker View Post
SOLVED
Having no information on the components, I replaced the damaged capacitor on the PQ900 -> DRAIN-> GND with
a value of 10 mF. After installing win10 the video card and its memory are detected correctly. The ACPI BSOD message is resolved without reprogramming the bios
chorumluum is offline   Reply With Quote
Old 01-03-2020, 02:38 PM   #27
jasko_jacker
Badcaps Veteran
 
Join Date: Oct 2014
City & State: roma
My Country: italy
Line Voltage: 220 V
I'm a: Knowledge Seeker
Posts: 934
Default Re: Dell INSPIRION 15 7567 BSOD

With the components in place the measurements regards a network of components not only the component to detect
Attached Images
File Type: jpg DELL 7567 DDR4 POWER_1.jpg (274.0 KB, 42 views)
jasko_jacker is offline   Reply With Quote
Old 01-03-2020, 03:25 PM   #28
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by jasko_jacker View Post
With the components in place the measurements regards a network of components not only the component to detect
Replacing to resistor but we give to energy only 0.13 amp 19.7 volts. Other engineer check now for short circut. Can you give me any suggest for testing?
chorumluum is offline   Reply With Quote
Old 01-11-2020, 10:51 AM   #29
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

up
chorumluum is offline   Reply With Quote
Old 06-11-2021, 12:02 AM   #30
reformatt
Badcaps Veteran
 
Join Date: Feb 2020
City & State: Noosaville
My Country: Australia
Line Voltage: 240V 50hz
I'm a: Professional Tech
Posts: 315
Default Re: Dell INSPIRION 15 7567 BSOD

I had a very similar fault to this on the same motherboard. With a Windows 10 USB boot disk, you'd get to the spinning dots for a brief moment and it'd restart. It ran Ubuntu Linux though, but this was only using the Intel GPU, not the Nvidia GPU. It wasn't even detected.

When I took the board out, PL900 had burnt up. It's a choke, inline with +B supply that feeds the +1.35VS_VGA buck converter. Turned out one of the caps PC902/903 was shorted. It turned out to be the one on the underside of the board. So replaced that and PL900 with one off a donor board, and all working ok.

Obviously Windows 10 crashed because it couldn't initialise the Nvidia GPU. Ubuntu just didn't care.
reformatt is offline   Reply With Quote
Old 11-07-2021, 07:50 PM   #31
rundllexe
New Member
 
Join Date: Nov 2021
City & State: VIC
My Country: Australia
I'm a: Knowledge Seeker
Posts: 2
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by reformatt View Post
I had a very similar fault to this on the same motherboard. With a Windows 10 USB boot disk, you'd get to the spinning dots for a brief moment and it'd restart. It ran Ubuntu Linux though, but this was only using the Intel GPU, not the Nvidia GPU. It wasn't even detected.

When I took the board out, PL900 had burnt up. It's a choke, inline with +B supply that feeds the +1.35VS_VGA buck converter. Turned out one of the caps PC902/903 was shorted. It turned out to be the one on the underside of the board. So replaced that and PL900 with one off a donor board, and all working ok.

Obviously Windows 10 crashed because it couldn't initialise the Nvidia GPU. Ubuntu just didn't care.
Hi reformatt, I believe I have the exact same issue on my 7567 - I'm in contact with Dell on a replacement board but expect it to be significantly priced. I also live in Aus (down in Melbourne) so was wondering as an alternative if I could commission you to repair the fault in my laptop? I was going to PM you but don't have permissions yet due to being brand new to the forums. Cheers!
rundllexe is offline   Reply With Quote
Old 11-07-2021, 10:34 PM   #32
reformatt
Badcaps Veteran
 
Join Date: Feb 2020
City & State: Noosaville
My Country: Australia
Line Voltage: 240V 50hz
I'm a: Professional Tech
Posts: 315
Default Re: Dell INSPIRION 15 7567 BSOD

Attached are some photos of the damage. The fault was the capacitor underneath going short, which blew the inductor on the top side. Have a look in this area of the board to see if you have the same fault. That one hasn't come back since it was repaired.

I'm up in Noosa if you want to send it to me.
reformatt is offline   Reply With Quote
Old 11-07-2021, 10:47 PM   #33
rundllexe
New Member
 
Join Date: Nov 2021
City & State: VIC
My Country: Australia
I'm a: Knowledge Seeker
Posts: 2
Default Re: Dell INSPIRION 15 7567 BSOD

Thanks mate - I figured out how to send you a PM in the interim as well

I'll get to work disassembling the unit tonight to check and upload some photo's. Cheers!
rundllexe is offline   Reply With Quote
Old 03-30-2022, 09:40 AM   #34
Gaboorigin
New Member
 
Join Date: Mar 2022
City & State: Merida
My Country: Mexico
I'm a: Knowledge Seeker
Posts: 6
Default Re: Dell INSPIRION 15 7567 BSOD

I have the same problem with my dell 7567 PL900 is burned out so ig you all can help me because no one in my country know how to solve the problem
Gaboorigin is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Badcaps.net Technical Forums © 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 03:12 AM.
Did you find this forum helpful?