I am not sure if this has been asked before but, I will appreciate everyone's help from everyone here
Macbook schematics show gnd and agnd
Upon checking ohm reading from agnd to a screw hole it is connected
One of the cap pads goes to agnd that is ripped, so i was thinking to scrape where the agnd pad and make a ground pad
If I were to connect this cap that goes to agnd to the scraped pad, gnd
what would happen?
But why does the schematic show two grounds but practically they are going to the same place?
Thanks all
Macbook schematics show gnd and agnd
Upon checking ohm reading from agnd to a screw hole it is connected
One of the cap pads goes to agnd that is ripped, so i was thinking to scrape where the agnd pad and make a ground pad
If I were to connect this cap that goes to agnd to the scraped pad, gnd
what would happen?
But why does the schematic show two grounds but practically they are going to the same place?
Thanks all
Comment