Hello,
The router hangs at bootloader stage without any error. This is the log from UART:
No matter what i choose, the result is the same.
The router hangs at bootloader stage without any error. This is the log from UART:
Code:
U-Boot 1.1.3 (Mar 6 2012 - 17:34:10) Board: Ralink APSoC DRAM: 64 MB relocate_code Pointer at: 83fb0000 spi_wait_nsec: 3c spi device id: c2 20 17 c2 20 (2017c220) find flash: MX25L6405D raspi_read: from:30000 len:1000 .*** Warning - bad CRC, using default environment ============================================ Ralink UBoot Version: 3.6.0.1_a3 -------------------------------------------- ASIC 3352_MP (Port5<->None) DRAM_CONF_FROM: Boot-Strapping DRAM_TYPE: DDR2 DRAM_SIZE: 512 Mbits DRAM_WIDTH: 16 bits DRAM_TOTAL_WIDTH: 16 bits TOTAL_MEMORY_SIZE: 64 MBytes Flash component: SPI Flash Date:Mar 6 2012 Time:17:34:10 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ##### The CPU freq = 384 MHZ #### estimate memory size =64 Mbytes uboot: NBG-419N v2 Power LED...on Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 6: To emergency. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. a: Auto load system code then write to Flash via TFTP. 4 You choosed 4 0
Comment