1 with dxe driver (you find manual and dxe driver on forum here)
2 read mec chip with svod 3 and clean password area
If i chose 2nd option then cannot edit Dmi information like serial number or UUID info always error or tool cannot support this laptop better i suggest find dxe driver and solve i better option
with svod you can reset password in mec (but risk) best way unlock patch with dxe driver, after unlock use lenovo uuid tool (boot from usb) then edit serial etc etc
(the dxe driver is allready post on this forum, and when you decompiler the patch you dont need a key!)
EC (with MEC) programming methode is very risky and involes soldering several very tiny resistors while soldering to very narrow traces (testpoints if you're lucky). So this is nothing you can do in 5min.
BTW: All this TPM and multiple location stuff that is claimed on some sites is BS.
Password in the secret area (mostly 2kb) is stored on the last "page" in the EC.
svod is not dangerous if you know what you are doing, and if you can do a little soldering you are not at risk, it is true that there is a small piece in mec reserved for certain settings, but with the latest update software (from svod 3) this is not problem! however I always recommend the dxe driver because then you don't have to solder and you don't have to program
press F1 to enter setup: password 1234
wait 20sec or more.
Enter any ID to hardware Id.
Press 2x space bar when asked.
Turn off the computer.
and restore your original bios .
Hello everybody, I have a Lenovo Thinkpad T560 6th gen and I would like to activate 'boot from usb' option in Bios but it is blocked with a supervisor password.
Can you help to bo the necessary steps?
Nico Latour, it seems you are French, can you help by contacting me if you see this mesage?
Thanks
Hello everybody, I have a Lenovo Thinkpad T560 6th gen and I would like to activate 'boot from usb' option in Bios but it is blocked with a supervisor password.
Can you help to bo the necessary steps?
Nico Latour, it seems you are French, can you help by contacting me if you see this mesage?
Thanks
patch ok on this model
need read bios with programer
Thanks a lot Maxpower. What do you recommend as programmer?
And do you recommend also SOIC8 clips?
Other question : I read on different forums that some Lenovo Thinkpads could be unlocked only by a shortcut between pin5 and 6 of the Eeprom at startup. Could it be possible for me?
Thanks a lot Maxpower. What do you recommend as programmer?
And do you recommend also SOIC8 clips?
Other question : I read on different forums that some Lenovo Thinkpads could be unlocked only by a shortcut between pin5 and 6 of the Eeprom at startup. Could it be possible for me?
Thanks for help
I don't like clips, programming I use tl866 works very well for that
.
Do not bypass pins 5 and 6 of the eeprom !!!! this is reserved for models with 24rf08
Comment