second try at this post...1st one blanked out on me so I posted nothing.
So here is the quick version this time
I have 3 Enermax Liberty ELT 500AWT --- made 2005
2 have crapped out on me.
My computer will not start...used the 3rd good one and computer powers up.
so not the mobo..
1) I jumpered power cable to ground( Green to Black). Fans on both came on..
2) checked Volts on power cable to computer. All get 3.31v, 5.14v, 12.27v ,and -11.86v. ATX power is 12.27V..both PSU's readings are exactly the same
3) pci cables get 12.27v also.
4) I put a few fans(Molex connector) on the PSU and ran them...all ports (modular PSU) on both rails ran the Fans.
5) have looked at most of the CAPs and they look good..no bulges or leaking
So what other T/S tips can I do to figure out why these seemingly good PSU's are not booting my computer up ?
Thanks in advance
AP514
So here is the quick version this time
I have 3 Enermax Liberty ELT 500AWT --- made 2005
2 have crapped out on me.
My computer will not start...used the 3rd good one and computer powers up.
so not the mobo..
1) I jumpered power cable to ground( Green to Black). Fans on both came on..
2) checked Volts on power cable to computer. All get 3.31v, 5.14v, 12.27v ,and -11.86v. ATX power is 12.27V..both PSU's readings are exactly the same
3) pci cables get 12.27v also.
4) I put a few fans(Molex connector) on the PSU and ran them...all ports (modular PSU) on both rails ran the Fans.
5) have looked at most of the CAPs and they look good..no bulges or leaking
So what other T/S tips can I do to figure out why these seemingly good PSU's are not booting my computer up ?
Thanks in advance
AP514
Comment