ViewSonic VA1930WM VS11354 won't power on

[PlainBill]

Re: ViewSonic VA1930WM VS11354 won't power on

Thanks for answer.
History of monitor is unknown
PCB's with all elements looks like new. I'm from Europe, so have 230V voltage.
As for diagram 2. No Power & Power LED Off, I checked voltage on IC802 pin6 and that is 0. I checked pin6 with GND.
But I have 5.2V on 1.2 pins of CN801...

I did a quick review of the Service Manual, and don't have to0 many suggestions. The overwhelming odds are it is a failure of the signal card. This may be a failure of the processor, a bad solder joint, or some component is bad. This eBay auction has a signal board (logic board) for $15. If you can persuade him to ship 'across the pond' you don't have to spend hours on what is most likely a futile exercise.

PlainBill

[3apa3a]

Re: ViewSonic VA1930WM VS11354 won't power on

Thank You man. It's WORKS ! Only for $22.5