Announcement

Collapse
No announcement yet.

Panasonic TX-48CX400B low LED volts

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #21
    Re: Panasonic TX-48CX400B low LED volts

    This seems to be a common problem with no solution. Ive got the same problem and I checked all leds and theyre fine. Just have to wait till I get a working set in so I can swap boards.

    Comment


      #22
      Re: Panasonic TX-48CX400B low LED volts

      Same problem here IC heating up to 110 degrees C then cuts out

      Comment


        #23
        Re: Panasonic TX-48CX400B low LED volts

        Originally posted by Duranitron View Post
        its not normal for the mp3394s to heat up if you have the schematics try to check all components surrounding the ic. also check the OVP circuit if you have an led backlight tester with current display let it fire up all the LED backlight from 80volts to 120vdc and let it lit for about 30min to an hour to isolate the problem that the LED backlight is not the culprit. my experience is 80vdc to 120 vdc current read out of 300mA max. it can pump up to 48 watts thats ok. there is always a possibility of shorting led when it reach the normal voltage so this test will surely catch it.check also if it has mosfet connected to the IC. hope you fix it just try and don't over see the obvious.
        Do you have schematics or know where I can get them fit this board

        Comment


          #24
          I have similar issue where boars states 400V and I am measuring 160.

          Comment

          Working...
          X