The central pin on power jack was broken and shorted the motherboard...
First i replaced power jack, then i find short on pch and it8585...Replaced pch and it8585...then i found short on PWM CONTROLLER NCP81103, so i replaced it also....as far as i can see i have voltage everywhere but cpu is not opening (Gpu is turning on 0,8v).
all_system_pwrgd 3,3v
h_dram_pwrgd 0,71v (low?)
but on logic drampwrok is not opening, 0v!
What am i missing? the resistence on +vcore is arround 30 ohm!
I attached the boardview, its the same as g501 just flip the board horizontally.
First i replaced power jack, then i find short on pch and it8585...Replaced pch and it8585...then i found short on PWM CONTROLLER NCP81103, so i replaced it also....as far as i can see i have voltage everywhere but cpu is not opening (Gpu is turning on 0,8v).
all_system_pwrgd 3,3v
h_dram_pwrgd 0,71v (low?)
but on logic drampwrok is not opening, 0v!
What am i missing? the resistence on +vcore is arround 30 ohm!
I attached the boardview, its the same as g501 just flip the board horizontally.
Comment