Post your original bios backup and post a good readable picture of the white/green sticker with the barcode/QR code on it .Its best to program the bios with an spi programmer if you have one. Winflash does have a force option though .
Post your original bios backup and post a good readable picture of the white/green sticker with the barcode/QR code on it .Its best to program the bios with an spi programmer if you have one. Winflash does have a force option though .
Hello I added photos and bios.This is the bios file that asus accepts and installs with its own program.and i added the latest version 307
Re: Asus main board : X555ld rev 2.0 & rev 3.3 & rev 3.6 bios
hello friends
asus x555LD rev.3.3(Case code:k555lb)but inside bios x555lbd.307(i think wrong bios)
n16s-gt-s-a2 nvidia chip inside.intel gpu work fine but gt940m is code 43 ?
please help me
Sure,if other methods to flash don`t work.The CH341A black pcb version might need modifying. Check if its output is 5V on pin 28,if so then do the 3.3V mod - https://www.chucknemeth.com/usb-devi.../3v-ch341a-mod ,there are youtube videos too and lots of other info about the mod if you search
hello friends
asus x555LD rev.3.3(Case code:k555lb)but inside bios x555lbd.307(i think wrong bios)
n16s-gt-s-a2 nvidia chip inside.intel gpu work fine but gt940m is code 43 ?
please help me
(334) X555LB on the white sticker is the bios that the board shipped with. So you need a X555LB bios
Hi again i received programmer(yes black pcb). created backup add here.I tried to write from ami before but bios did not accept it because it shows 306 ldb
Hi again i received programmer(yes black pcb). created backup add here.I tried to write from ami before but bios did not accept it because it shows 306 ldb
see posts 15 and 17 .The bios at post 17 has your DMI + win key added .
Hi again i received programmer(yes black pcb). created backup add here.I tried to write from ami before but bios did not accept it because it shows 306 ldb
The backup is not good,its corrupted, theres a few reasons for it.
The clip isn`t held on steady or its not making good contact.
The 3.3V volt mod hasn`t been done
The default software is shit
Comment