If I am not mistaken, it is just insulated high-voltage 10MΩ resistor inside the probe plus some tweaking capacitor on the BNC side, right?
So if I wanted to embed BNC for measuring AC line output of a device, I could just hook 10MΩ HV resistor in series on the center pin of the BNC connector inside the device and than connect it with BNC-BNC coaxial directly to O-scope? OFC the device must always be turned on AFTER conecting the cable because of the risk of electrocution, I am aware of that.
So if I wanted to embed BNC for measuring AC line output of a device, I could just hook 10MΩ HV resistor in series on the center pin of the BNC connector inside the device and than connect it with BNC-BNC coaxial directly to O-scope? OFC the device must always be turned on AFTER conecting the cable because of the risk of electrocution, I am aware of that.
Comment