I have a Sony kdl-75w850c won't turn on no lights or noise haven't tore apart yet was looking for advice thanks
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
Kdl-75w850c
Collapse
X
-
Re: Kdl-75w850c
Get meter, take the back off and do visual inspection and then start taking Voltage measurement.
Also need to upload good clear pictures of the whole back side of the TV showing all the boards so we can see what we are dealing with.Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956
Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999
Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl
Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/
TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809
-
Re: Kdl-75w850c
Originally posted by Ovalking View PostThanks it has power red light blinks 6 times
Do you see "SONY" flashed briefly when you turn on from a reset? If not, your problem may lie on the power supply end of the backlight (if you're lucky).
Comment
-
Re: Kdl-75w850c
There are two LED zones. If only one LED is bad, then you should see a flash of the good zone, which should light up the SONY logo (less than 0.25 seconds). If that happens, then you will have to perform open heart surgery to get at the LEDs. I have a post for a KDL-65W850C version of this series TV detailing my successful replacement of an LED.
Comment
-
Re: Kdl-75w850c
I just finished doing a backlight repair on this Tv now that the backlight kits are available again at ShopJimmy but it's a nightmare to do compared to most backlight repairs. Teardown went normal once you get all the various brackets, IR sensor and wifi out of the way. Each side has it's own wrap around bezel and the panel has side tabs that protects them. One thing I advise is pay attention to the corner L shaped brackets and bottom bezel brackets before they fall out once you take out the screws because they are a pain in the butt to align when you put everything together. Be careful removing the clear plastic stations that holds the defusers and panel away from the leds because they clip back in and never fit tight when reinstalling so I used a dab of clear silicone to hold them down. Take a picture of where everything goes and in what order you took it apart. The bottom bezel is a pain to line up to get the small screws in those brackets. Total time was about 8 hours. That's twice the time I usually spend on a backlight repair. There was one burnt out strip in the middle which caused the six blink error code. I rarely see Sony's come in for backlight repairs and that is good because they are never easy compared to most models.
Comment
Comment