![]() |
|
|
Thread Tools | Display Modes |
![]() |
#101 |
Member
Join Date: Nov 2020
City & State: Vienna
My Country: Austria
I'm a: Knowledge Seeker
Posts: 65
|
![]() I'm unsure if this is actually the most pointless fix I've ever made, but it sets the bar quite high, even for my standards. At least I had it for around five more years.
|
![]() |
![]() |
![]() |
#102 | |
Badcaps Veteran
Join Date: Jul 2011
City & State: Some times Sunny Jacksonville FL
My Country: USA
Line Voltage: 120 Volts 60 HZ
I'm a: Knowledge Seeker
Posts: 3,569
|
![]() Quote:
![]()
__________________
9 PC LCD Monitor 6 LCD Flat Screen TV 30 Desk Top Switching Power Supply 10 Battery Charger Switching Power Supply for Power Tool 6 18v Lithium Battery Power Boards for Tool Battery Packs 1 XBox 360 Switching Power Supply and M Board 25 Servo Drives 220/460 3 Phase 6 De-soldering Station Switching Power Supply 1 Power Supply 1 Dell Mother Board 15 Computer Power Supply 1 HP Printer Supply & Control Board * lighting finished it * These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10% 1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later ) 2 Hem Saw Computer Stack Board All of these had ![]() All of the mosfet that are taken out by bad caps ![]() |
|
![]() |
![]() |
![]() |
#103 |
Member
Join Date: Nov 2020
City & State: Vienna
My Country: Austria
I'm a: Knowledge Seeker
Posts: 65
|
![]() The tape was there since almost forever, after I accidently stepped on it once. The more recent Sunday-evening fix was the external power switch, after the original one went up in smoke haha
|
![]() |
![]() |
![]() |
#104 |
Super Moderator
Join Date: Jul 2005
City & State: ----
My Country: Sweden
Line Voltage: 230v 50Hz
I'm a: Knowledge Seeker
Posts: 5,133
|
![]() vollgas
standgas LOL! ![]()
__________________
"The one who says it cannot be done should never interrupt the one who is doing it." |
![]() |
![]() |
![]() |
#105 |
Solder Sloth
Join Date: Nov 2012
City & State: CO
My Country: USA
Line Voltage: 120VAC 60Hz
I'm a: Hobbyist Tech
Posts: 7,163
|
![]() No, not pointless or worthless at all, you saved it from the landfill (unless you paid more for the switch than buying a new heat gun... then it would indeed qualify)!
However... definitely qualifies for ghetto fix in any circumstance! "vollgas" and "standgas" are cute for reading as straight English, but probably quite typical for German...? |
![]() |
![]() |
![]() |
#106 |
Super Moderator
Join Date: Jul 2005
City & State: ----
My Country: Sweden
Line Voltage: 230v 50Hz
I'm a: Knowledge Seeker
Posts: 5,133
|
![]() |
![]() |
![]() |
![]() |
#107 |
Member
Join Date: Nov 2020
City & State: Vienna
My Country: Austria
I'm a: Knowledge Seeker
Posts: 65
|
![]() |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|