Hi,
The board is ALiveNF7G-HDready.
It was with Windows XP and i plan to install Windows 10.
On 1 USB i plug my mouse and it doesn`t recognize it.
I change USB port and it work.
I turn it off, but display goes off, but fans continue to work.
Then i unplug it from power.
Then it try to start, but again problems with USB, some restarts and
it stop working.
It only start fans and nothing else.
I remove RAM, but there is no beep from speaker.
Diagnostic card says 75, F0 and stop.
Try with other CPU and other PSU, but the same result.
I remove bios chip and reprogram it with the latest ROM.
Battery was 1,2V and i change it with new one. Also try to reset BIOS
with removing battery and with jumper.
On mainboard there is some mosfets in 2 rows.
First row is with 72T02GH and on their Drain there is 12V.
Other row is with 86T02GH and on their Drain there is 1.1v.
Any ideas how to repair it?
The board is ALiveNF7G-HDready.
It was with Windows XP and i plan to install Windows 10.
On 1 USB i plug my mouse and it doesn`t recognize it.
I change USB port and it work.
I turn it off, but display goes off, but fans continue to work.
Then i unplug it from power.
Then it try to start, but again problems with USB, some restarts and
it stop working.
It only start fans and nothing else.
I remove RAM, but there is no beep from speaker.
Diagnostic card says 75, F0 and stop.
Try with other CPU and other PSU, but the same result.
I remove bios chip and reprogram it with the latest ROM.
Battery was 1,2V and i change it with new one. Also try to reset BIOS
with removing battery and with jumper.
On mainboard there is some mosfets in 2 rows.
First row is with 72T02GH and on their Drain there is 12V.
Other row is with 86T02GH and on their Drain there is 1.1v.
Any ideas how to repair it?
Comment