Dim Clock LCD on Jenn-Air wall oven

**Longbow** · 09-13-2011, 10:42 AM

The code FC means "communication error between boards". Mostly likely the flexible plastic connector is not plugged in correctly to the timer board, or the wired connector is in the wrong position. Pressing "Cancel/Off" will stop the beeping, but if the error is still present the beeping will continue. Re-check your connectors. The flexible cable is a bit difficult to install.

09-13-2011, 10:42 AM	#11
Longbow Badcaps Veteran Join Date: Jun 2011 City & State: Brighton, U.K. Posts: 621	Re: Dim Clock LCD on Jenn-Air wall oven The code FC means "communication error between boards". Mostly likely the flexible plastic connector is not plugged in correctly to the timer board, or the wired connector is in the wrong position. Pressing "Cancel/Off" will stop the beeping, but if the error is still present the beeping will continue. Re-check your connectors. The flexible cable is a bit difficult to install. __________________ Is it plugged in?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode