Hi. I'm busy troubleshooting my Samsung Frame TV UN65LS003 on another thread, but I had a separate question I'm hoping someone here may have an answer for.
The service manual states that after replacing the main board you should "change the factory option. The options you must change are 'Type'." I've linked the service manual (page 57). It also states you should "change option bytes when replacing Main Board".
The only change I made was going to service menu -> Option -> Type -> 65A1AUOKM
That's all I did. I checked firmware was updated (it was). My intermittent issues continue as before. Is there something else I need to do to "change option bytes"?
The service manual states that after replacing the main board you should "change the factory option. The options you must change are 'Type'." I've linked the service manual (page 57). It also states you should "change option bytes when replacing Main Board".
The only change I made was going to service menu -> Option -> Type -> 65A1AUOKM
That's all I did. I checked firmware was updated (it was). My intermittent issues continue as before. Is there something else I need to do to "change option bytes"?
Comment