Hi Badcappers, I'm after some advice.
I've installed LED strip lighting in my office/workshop, it comes in 5m lengths and i've been powering it off my bench power supply. A 5m length is drawing 2.42A and when i had 10m attached in parallel i've noticed the outputs of my power supply get quite warm/hot.
I decided i needed a proper driver and bought a R-200-12 a 12v 16.5A LED power supply as it seemed as it would have some spare capacity.
Obviously i opened it up as the QC inspected sticker was already broken.
Dongbaohe and Twco caps inside, (i've never heard of Dongbaoe)
I was going to connect the wires from my ceiling light to the L N and earth and connect 3 or 4 5m lengths of the LED strip in parallel to the V+ and COM.
I guess the voltage pot is then adjusted to 12v ?
Am i correct in my way of connecting and setting this up.
Should i replace those caps ?
Thank you.
I've installed LED strip lighting in my office/workshop, it comes in 5m lengths and i've been powering it off my bench power supply. A 5m length is drawing 2.42A and when i had 10m attached in parallel i've noticed the outputs of my power supply get quite warm/hot.
I decided i needed a proper driver and bought a R-200-12 a 12v 16.5A LED power supply as it seemed as it would have some spare capacity.
Obviously i opened it up as the QC inspected sticker was already broken.
Dongbaohe and Twco caps inside, (i've never heard of Dongbaoe)
I was going to connect the wires from my ceiling light to the L N and earth and connect 3 or 4 5m lengths of the LED strip in parallel to the V+ and COM.
I guess the voltage pot is then adjusted to 12v ?
Am i correct in my way of connecting and setting this up.
Should i replace those caps ?
Thank you.
Comment