I'm trying to fix my kitchenaid food processor KFP750WH. The on button will press properly and the light will go on, but it will not run.
I've experienced this before and taken it apart, and previously there would be a connection that simply disconnected. I would reattach it and it would be fine. Now, that connection is burnt and partially broken off.
I put a few pictures here. I have no problem getting my hands a little dirty but can't figure out the best way to remake this connection. The male part where it attaches seems to have a little coating from the plastic from the wire (female) attachment. I'm assuming i can scratch this coating off. The female connector is unfamiliar to me with regards to naming it and getting a replacement, if possible.
thanks for any help.
I've experienced this before and taken it apart, and previously there would be a connection that simply disconnected. I would reattach it and it would be fine. Now, that connection is burnt and partially broken off.
I put a few pictures here. I have no problem getting my hands a little dirty but can't figure out the best way to remake this connection. The male part where it attaches seems to have a little coating from the plastic from the wire (female) attachment. I'm assuming i can scratch this coating off. The female connector is unfamiliar to me with regards to naming it and getting a replacement, if possible.
thanks for any help.
Comment