Hi
My miter saw like lots of things at the moment seems to have given up.
I'm getting 240v to the switch, which I've tested for resistance when pressed giving about 0.08 ohms so i assume is OK
The start capacitor has a rating of 0.47uf and I'm reading about 0.35uf, could this be the issue?
The motor on the machine is a brushed type with two wires connected to it, should I be reading low resistance between these wires.
Is there a way to test if the brushes are worn?
My miter saw like lots of things at the moment seems to have given up.
I'm getting 240v to the switch, which I've tested for resistance when pressed giving about 0.08 ohms so i assume is OK
The start capacitor has a rating of 0.47uf and I'm reading about 0.35uf, could this be the issue?
The motor on the machine is a brushed type with two wires connected to it, should I be reading low resistance between these wires.
Is there a way to test if the brushes are worn?
Comment