Hello,
I hope this is in the correct thread. Regarding TAICON caps, I have a Dell E153FPc lcd with bad caps in the power inverter board (715L1074-H). The obviously bad one is a HERMEI 1000uF 16V. It had swollen upward out of the plastic coat to the point I thought it was a different type capacitor. There is another of same specs, still looking normal but I figure to replace it based on the failure of its sibling.
I have two TAICOM 1000uF 16V (10x16mm) of the "HI" series. Would these be an acceptable replacement? Taicom spec sheet indicates a ripple value of 2000 for this paticular cap.
The other caps are smaller HERMEI 470uf 16V (purple jacket w/ silver lettering), one 150uF 25V, others are small non-suspect values.
Thanks in advance for any help.
I hope this is in the correct thread. Regarding TAICON caps, I have a Dell E153FPc lcd with bad caps in the power inverter board (715L1074-H). The obviously bad one is a HERMEI 1000uF 16V. It had swollen upward out of the plastic coat to the point I thought it was a different type capacitor. There is another of same specs, still looking normal but I figure to replace it based on the failure of its sibling.
I have two TAICOM 1000uF 16V (10x16mm) of the "HI" series. Would these be an acceptable replacement? Taicom spec sheet indicates a ripple value of 2000 for this paticular cap.
The other caps are smaller HERMEI 470uf 16V (purple jacket w/ silver lettering), one 150uF 25V, others are small non-suspect values.
Thanks in advance for any help.
Comment