X555ld rev 3.3

[hallmark1730]

Originally Posted by SMDFlea

see posts 15 and 17 .The bios at post 17 has your DMI + win key added .

Use neoprogrammer or asprogrammer software

https://www.badcaps.net/forum/showpo...04&postcount=7 NeoProgrammer

https://www.badcaps.net/forum/showpo...6&postcount=10 AsProgrammer

Thanks neoprogrammer is good list my chip mx25l6473e.Can I write the bios file directly? or do I need to find a dump file.i found a x555lb orijinal dump file Which one should I use
3.3 volt mode mandatory?

[hallmark1730]

i try programing but error this
Protection may be enabled. Press "Unprotect" and check datasheet
Current programmer: CH341
Old SREG: 01000000(0x40),
New SREG: 11111111(0xFF),
Programming memory(verifying)...
Verification error on address: 00000005
Execution time: 00:00:00.048
Current programmer: CH341
SPI ID: 2017C2
Current programmer: CH341
15:07:18
Protection may be enabled. Press "Unprotect" and check datasheet
Current programmer: CH341
Old SREG: 11110011(0xF3),
New SREG: 01000000(0x40),
Programming memory(verifying)...
Verification error on address: 0000000E
Execution time: 00:00:00.049

[SMDFlea]

Use the bios at post #17 ,i told you i added your DMI (serial number etc) and win key to it. Change neoprogrammer hardware settings to use ch341a . Manually choose the mx25l6473e ,then erase the chip,then open the file from post #17 and program

[hallmark1730]

I did the way you say. But I get the same error. please help me

[SMDFlea]

plug the charger in,and the laptop off and try again

[hallmark1730]

if plug the charger do not read or write add picture.
Even when I disconnect the usb, the light is on the programmer

NEW EDİT:I don't know why, but now he programed it. Windows is opening, I will check if my video card problem is fixed

[hallmark1730]

You are a best.Thank you very very much.you were very patient, kind and helpful

[hallmark1730]

I'm very sorry. The graphics card is working properly.I wanted to do a clean install because the pc is slowing down after bios reprogramed.but windows installation stuck at copying windows files 0%.try different usb-iso-diskpart-bios secure boot disabled but dont work.I can't clean install

[hallmark1730]

ok i solved it clean a contack cleaner for motherboard and harddisk board connector its work

[bilinch]

Originally Posted by SMDFlea

Try the attached bios,flash with AFUwin from here - https://www.ami.com/download/aptio-v...pdate-utility/

Thanks a lot 4 this correct bios for gt 940m. Code 43 error disappeared now. I change win key to blank and write the original case serial number to this bios.
Everything is perfect.

[khelane]

hi
i have x555ld rev3.3

This device was programmed before it reached me and it has this problem. I tried a some BIOS now, but it is slow. It even shows the clean me file in the attachment.
I tested 3 or 4 BIOS, but it still shows up late
me BIOS version tested:
Version: 10.0.38.1000
Version: 10.0.30.1072
pls help me
tnx

[SMDFlea]

Post a picture of the sticker on the motherboard

Example https://i.postimg.cc/hP69RBW0/aaa.jpg

https://www.badcaps.net/forum/showthread.php?t=96604

[khelane]

It was my own fault. I had to clean the bios file myself. Instead, I went and downloaded the cleaned bios file. Finally, I made the BIOS with the appropriate me file and it was over
I attached the file for the site, maybe it was useful for someone

Thanks