Does anyone know how best to re-adhere ferrite beads and strain relievers to cables, like when repairing a games console controller that has had wires broken near where the cable emerges from the controller?
I found that the bead and reliever need to have a twist drill passed through to allow a fresh part of the cable to go through when the bad portion of cable was cut away. The material that came out was hard like the plastic cable cover, not like a silicone based material I half expected.
Does anyone know how it's done at the factory?
I found that the bead and reliever need to have a twist drill passed through to allow a fresh part of the cable to go through when the bad portion of cable was cut away. The material that came out was hard like the plastic cable cover, not like a silicone based material I half expected.
Does anyone know how it's done at the factory?
Comment