Badcaps.net Forum
Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Troubleshooting Audio Equipment
Register FAQ Calendar Search Today's Posts Mark Forums Read

 
Thread Tools Display Modes
Old 01-03-2021, 08:36 AM   #1
XgN
New Member
 
Join Date: Apr 2019
City & State: Kaunas
My Country: Lithuania
I'm a: Knowledge Seeker
Posts: 6
Default Onkyo TX-NR807 no sound problem

Hi guys!

Got this Onkyo monster with a defect - it has no sound through speaker outputs as well as headphones (previously stated as fully working). Okey, thought it is a common problem of DTS IC or its firmware as the all others I have repaired before. Carefully inspected DSP IC, seems to be changed to the newest version (with a letter "D") and all FWs show OK.

Started troubleshooting with a DMM and scope.
Checked signal path and the signal is missing just after Q5501 - R2A15220FP - Input MUX IC. Checked before caps C5600 and C5601 so that Mute does not affect signal (if such is present). Voltage rails are OK, though (Please refer to the chematics part presented below).
https://ibb.co/kX1TsSw

How likely this IC is damaged? Have anyone had such experience where R2Axxxxx Input Selector was defective?

Looking forward to hearing!

Last edited by XgN; 01-03-2021 at 08:39 AM..
XgN is offline   Reply With Quote
Old 01-03-2021, 09:03 AM   #2
madan1
Badcaps Veteran
 
Join Date: Nov 2016
City & State: Sofia
My Country: Bulgaria
I'm a: Knowledge Seeker
Posts: 462
Default Re: Onkyo TX-NR807 no sound problem

I remember seeing a video of a yamaha AVR repair, where the input selector/vol control was dead.
madan1 is offline   Reply With Quote
Old 01-03-2021, 12:11 PM   #3
schenckb
New Member
 
Join Date: Jan 2021
City & State: Minnesota
My Country: United States
I'm a: Knowledge Seeker
Posts: 9
Default Re: Onkyo TX-NR807 no sound problem

I will start my own thread on this, but I thought I'd offer some perspective:

I just had an HT-R590 receiver go bad. I get no sound from the speakers, but all video, FM tuner, etc functions seem to work. When I opened the unit, I noticed signs of heat (small burn mark) on the AMP board near the resistors for the +/-15V regulators, which is almost directly above the R2A15218FP (8 channel input selector) chip, which is undermounted to that board. I have been scratching my head trying to figure out the loss of audio output, considering all the relays seems to be functional (and this uses a wirebound (not flip-BGA) TI DSP chip on the HDMI board, which doesn't appear to be part of the big warranty extension from the last few years).

I would be very interested to see if, indeed, the R2A15218FP chip goes bad frequently. I'll be watching to see your pointers on isolating the issue to there.
schenckb is offline   Reply With Quote
Old 01-21-2021, 12:56 AM   #4
Lunaer
New Member
 
Join Date: Dec 2020
City & State: Los Angeles
My Country: USA
I'm a: Knowledge Seeker
Posts: 2
Default Re: Onkyo TX-NR807 no sound problem

Has the problem been solved? Is the integrated circuit damaged or the input selector defective?
Lunaer is offline   Reply With Quote
Old 01-21-2021, 04:43 AM   #5
zen
Member
 
Join Date: Apr 2011
Posts: 92
Default Re: Onkyo TX-NR807 no sound problem

Hello , no progress yet .

Have been really busy with other customer repairs , & needed to side line the amp for now , but be assured i won't give up till i trace route cause of the issue .

Will update soon as i have the opportunity to work on it again .

Regards Zen
zen is offline   Reply With Quote
Old 03-04-2021, 12:08 PM   #6
andyb1712
Member
 
Join Date: Oct 2018
City & State: Fareham
My Country: United Kingdom
Line Voltage: 240VAC 50Hz
I'm a: Professional Tech
Posts: 21
Default Re: Onkyo TX-NR807 no sound problem

I recently acquired one of these TX-NR807 with no audio and the main digital board has not had any of the usual mods... cap changes, daughter board voltage reg or DSP chip replaced.

I started by flowing some liquid flux under Q3001 (DSP, D830K013BZKB300) and reflowing it as I have done with other units that use this chip.

It now works fine, audio out, network etc. This chip was on the TI 'premature failure' list, so it remains to be seen how long it lasts.
andyb1712 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Badcaps.net Technical Forums 2003 - 2021
Powered by vBulletin ®
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 02:15 AM.
Did you find this forum helpful?