This unit will flash the backlights once on powerup. Still responds to remote commands, and plays audio.
I have a backlight tester.
Two backlight connections to PSU. I have them connected opposite of OEM in the picture.
CON301 - Red/White wire - tests 95.5v on my backlight tester.
CON302 - Red/Gray wire - tests 92.5v on my backlight tester.
Is a 3v difference between strips enough cause to tear down the panel? It doesnt trigger any red flags for me. The backlight flash is enough for me to knee-jerk blame bad backlight strips as a first guess assumption.
Voltages on PSU board
3 large main caps - 370v DC
GND
ADJ -
BK -
+5V - Not Connected
PSON -
+5VSB - Not Connected
NC - Not Connected
ND - Not Connected
GND
GND
GND
+12V - 11.98v
+12V - 11.98v
Edit: Model # is actually 100012588
I have a backlight tester.
Two backlight connections to PSU. I have them connected opposite of OEM in the picture.
CON301 - Red/White wire - tests 95.5v on my backlight tester.
CON302 - Red/Gray wire - tests 92.5v on my backlight tester.
Is a 3v difference between strips enough cause to tear down the panel? It doesnt trigger any red flags for me. The backlight flash is enough for me to knee-jerk blame bad backlight strips as a first guess assumption.
Voltages on PSU board
3 large main caps - 370v DC
GND
ADJ -
BK -
+5V - Not Connected
PSON -
+5VSB - Not Connected
NC - Not Connected
ND - Not Connected
GND
GND
GND
+12V - 11.98v
+12V - 11.98v
Edit: Model # is actually 100012588
Comment