When requesting help, please attach a picture of the board with voltage and resistance to ground measurements on all the large inductors after triggering power button.
When requesting help, please attach a picture of the board with voltage and resistance to ground measurements on all the large inductors after triggering power button.
..but resistance checks are to be performed always with the power OFF and with NO battery.
fixed by removing cmos battery and waited for some time, after few tries it worked. BIOS went mad i guess.
Other problem. trackpad doesnt work. I have second trackpad, and it doesn't work too.
Under windows 10, device manager is not detecting any trackpad. Doesnt work on latest ubuntu and windows 7 install setup.
Asus smart gesture driver is installed (W10).
Ouch! Review if you have a visible short on this line. According to the boardview diagram, this is a signal line and should be ~3v3 with no activity. This is common to I2C bus interfaces - the local pull-up performs this task.
The resistance is very low so suspecting that there is a solder short or a bad cap. Hunt the area for clues.
Possible short could be to pin # 5 = GROUND on the same connector.
Ouch! Review if you have a visible short on this line. According to the boardview diagram, this is a signal line and should be ~3v3 with no activity. This is common to I2C bus interfaces - the local pull-up performs this task.
The resistance is very low so suspecting that there is a solder short or a bad cap. Hunt the area for clues.
Possible short could be to pin # 5 = GROUND on the same connector.
Comment