Hi guys, I need a little bit of advice on this as i cannot get a schematic for it.
Upon powering up the tv the standby light is on but after about 2 seconds it goes off and remains off. Pushing the standby button makes no difference. No picture, no backlights nothing.
This is what i have observed. The panel voltage (12V) does not come on.
Various voltage points have been checked (please check photo) but i do not know if they are correct. Only suspicion is the DC to DC converter that;s outputting 1.15V. Maybe it is supposed to be 1.2V or 1.8V don't know.
What if the eprom is corrupt?
Couldnt find firmware anywhere for this board. Any help anyone?
Upon powering up the tv the standby light is on but after about 2 seconds it goes off and remains off. Pushing the standby button makes no difference. No picture, no backlights nothing.
This is what i have observed. The panel voltage (12V) does not come on.
Various voltage points have been checked (please check photo) but i do not know if they are correct. Only suspicion is the DC to DC converter that;s outputting 1.15V. Maybe it is supposed to be 1.2V or 1.8V don't know.
What if the eprom is corrupt?
Couldnt find firmware anywhere for this board. Any help anyone?
Comment