Olevia 747-B11 wounded by lightning

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Dunitagain
    Computer Svce
    • Jun 2014
    • 3
    • United States

    #1

    Olevia 747-B11 wounded by lightning

    I have a TV problem that started when powered on after a thunderstorm. I tuned it on, and it commenced to popping like hot popcorn. I restarted with the same results. Tearing it down to test I noticed A red LED(D1) next to speaker output plugs, when rear power switch toggled on. When TV turned on, I discovered (D2) red LED on. I had no picture or sound at this point. I checked board voltages at both power on levels and found on board (main board) to be missing +5vdc @CMO, and 12vdc @LPL. What do I look for now? I tried to find that board for sale, but no one had it on hand.

Related Topics

Collapse

  • Bardou Kari
    HP EliteBook 840 G6 – no power after lightning strike
    by Bardou Kari
    Hi,
    I’m trying to fix an HP EliteBook 840 G6 that stopped working after a lightning storm.

    – Charger is OK and 19V is present at the motherboard.
    – No charging LED, no fan, no reaction.
    – I don’t see any 3.3V or 5V near the coils.
    – Battery is unplugged.
    – I’m new to board repair but can use a multimeter.

    I added a clear photo of the board.
    Any idea where to start or what to check next?
    Thanks a lot for your help!...
    07-01-2025, 10:45 AM
  • Weissnix4711
    ASRock B650I Lightning WiFi boardview
    by Weissnix4711
    from https://www.badcaps.net/forum/troubl...g-wifi-no-boot...
    04-04-2025, 09:04 AM
  • Sam “Captain” W. C
    Corsair RM650 ATX, possibly struck by lightning
    by Sam “Captain” W. C
    Just starting out in electronics repair and teaching myself as I go.
    I have here a Corsair RM650 ATX PSU, which I'm treating as a learning project that if successful may be used in my PC.
    Fuse was blown, probable power surge from lightning, followed the circuit and found, a dead relay and all the diodes and resistors around the bridge rectifier shorted. Rectifier and MOSFETs seem fine on the LCR.
    Also found these tiny diodes on the other side, a few shorted, the rest seem fine. But they're not all marked as Zener on the pcb. So I'm unsure what these should be replaced with....
    06-12-2024, 09:52 AM
  • pfl
    ElectroVoice ETX-18SP (powered Subwoofer) damaged after lightning strike
    by pfl
    Hello Everyone.
    This powerful amplified subwoofer doesn't make any sound after lightning striked near the house were it was plugged in.
    It consists in :
    • a power board were the full H bridge class D amplifier and main power rails are located
    • a preamp board (ref. F.01U.299.771) receiving 2 symetrical inputs(IN1, IN2), a digital chain (A-D converter -> Digital Signal Processor -> D-A converter) and a micro controler in charge (at least) of the human interface (lcd display and 1 rotating button)
    Power rails are ok.
    human interface is working fine
    Input levels are...
    01-23-2024, 10:21 AM
  • Sraros
    17PW15-8 blows fuses after lightning
    by Sraros
    Hello,
    I picked this PSU 17PW15-8 from a friend's TV with a burnt fuse, after some days of rain and lightning strikes. The TV was on standby when it happened.
    With new fuses it burns them as well. I checked bridge rectifier, all the TO220 components, diodes and basic caps, replaced IC806 SMPS, and FETS driving the big transformer. I also isolated the secondary circuit by cutting the rails of the FETs to the primary coils. I don't know even know if that makes sense, but I did in hopes to isolate the problem.
    Any ideas what to look for?...
    12-04-2023, 01:26 AM
  • Loading...
  • No more items.
Working...