Dear Members,
I have Velodyne 10, it's on and responding to low frequency,
but the speaker is not vibrating properly,
Is it possible that the speaker is faulty or the amplifier ?
The speaker resistance is 7.8 Ohm when I put on meter, but I'm not sure it's ok.
Because it was getting a surge before,
I've fixed the bridge, switching FET and FET driver before, and also
the amplifier chip and FET are replaced,
Is it possible the speaker was burned as well, even it's 8 ohm, it's faulty ?
Thanks
I have Velodyne 10, it's on and responding to low frequency,
but the speaker is not vibrating properly,
Is it possible that the speaker is faulty or the amplifier ?
The speaker resistance is 7.8 Ohm when I put on meter, but I'm not sure it's ok.
Because it was getting a surge before,
I've fixed the bridge, switching FET and FET driver before, and also
the amplifier chip and FET are replaced,
Is it possible the speaker was burned as well, even it's 8 ohm, it's faulty ?
Thanks
Comment