I'm getting a much more magnified image on the camera of my trinocular microscope than the one I am seeing through the eyepieces
I set the camera to minimum zoom but it will not zoom out anywhere near enough to work properly.
Adjusting the vertical position of the camera on the microscope sets the focus, not the image size, so I have to position it at a set distance
I've asked the seller but before they answer, can anyone say if this is actually normal? Not having had a proper microscope before I have no experience.
Attached is a pic of the monitor screen and a pic taken through the eyepiece of the same PCB at the same magnification setting.
Rich
I set the camera to minimum zoom but it will not zoom out anywhere near enough to work properly.
Adjusting the vertical position of the camera on the microscope sets the focus, not the image size, so I have to position it at a set distance
I've asked the seller but before they answer, can anyone say if this is actually normal? Not having had a proper microscope before I have no experience.
Attached is a pic of the monitor screen and a pic taken through the eyepiece of the same PCB at the same magnification setting.
Rich
Comment