So i got this board with VRM short. Replaced one faulty mosfet and the buck controller and everything looked fine.NO shoring anywhere.
Then I reseated the the processor and ram. PLugged in and now I can see a green LED glow on the board itself.
But when I press the power button, it starts for about 10 seconds( fan spins) then shuts down. Nothing on display .. no post.
Upon checking the board againwith the multimer (after removing the CPU) , on buzzer mode the 4 pin socket does beep and is around resistance 035 ohms.
Is that normal ?
Then I reseated the the processor and ram. PLugged in and now I can see a green LED glow on the board itself.
But when I press the power button, it starts for about 10 seconds( fan spins) then shuts down. Nothing on display .. no post.
Upon checking the board againwith the multimer (after removing the CPU) , on buzzer mode the 4 pin socket does beep and is around resistance 035 ohms.
Is that normal ?
Comment