Announcement

Collapse
No announcement yet.

Need help ID graphics card cap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Need help ID graphics card cap

    Hello fellow electronics techs.

    This little guy broke off one of my junker cards that I normally do protein folding. Leads stuck to the card and yanked out of the cap.

    I can probably solder a new one without much trouble if I can decipher what these markings are. I'm guessing 16V 271 uF but really I have no idea. It doesn't have to be an expensive cap, just one that will do the job on an open test bench with plenty of air flow. I believe it was a filter cap for one of the VRAM ICs.

    It reads

    FP5K
    64Ch
    271
    16

    Thanks for looking.

    - Luke
    Attached Files

    #2
    Re: Need help ID graphics card cap

    It is a Nichicon FPCAP rated at 270uF and 16v

    https://eu.mouser.com/new/nichicon/nichiconfpcap/
    "The one who says it cannot be done should never interrupt the one who is doing it."

    Comment


      #3
      Re: Need help ID graphics card cap

      Originally posted by Per Hansson View Post
      It is a Nichicon FPCAP rated at 270uF and 16v

      https://eu.mouser.com/new/nichicon/nichiconfpcap/
      Thank you Per!

      I ordered a few from Digi-Key since Mouser wanted to charge like $20 to ship.

      I'll post a picture of finished project.
      Last edited by l_gel; 05-13-2021, 11:42 AM.

      Comment

      Working...
      X