Announcement

Collapse
No announcement yet.

Sharp LC-60E79U problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Sharp LC-60E79U problems

    Hello all, this tv wont power on. When I push power the light power led stays on 2 or 3 seconds then I hear a clicking noise from power supply board then the trouble codes flash (power light and ops flash together twice then the opc light flashes 3 times). If I test volts on initial power up everything reads normal until the clicking noise then they drop to zero, however the 12v pins to tcon board only read .6v when powering up. I can start the unit with hard reset by plugging AC in while holding down the vol down and input buttons and this will power up all the backlight and it no longer flashes trouble codes. I still can't use the tv in this state or get anything to pull up on the screen, when I do this all the volts hold accurate except the 2 12v pins going to the tcon board, they read .7v when I do this. The manual suggests its the power supply board according to the number of flashes but I want to make sure I'm not missing anything before ordering a power supply board.
    Thanks in advance, I'm new to this site but I'm very impressed and have learned a good bit from the members.

    #2
    Re: Sharp LC-60E79U problems

    pictures would be great.

    if you disconnect the t-con from the main (lvds cable), does the 12 stabilise, or is it still low?
    WHY CAN'T PHILIPS USE PHILLIPS HEAD SCREWS?

    Comment


      #3
      Re: Sharp LC-60E79U problems

      I can test voltage in the morning, with tcon disconnected from main, if the voltage goes up to 12, which board is to blame for the problem?
      Attached Files

      Comment


        #4
        Re: Sharp LC-60E79U problems

        Here is the picture of everything
        Attached Files

        Comment


          #5
          Re: Sharp LC-60E79U problems

          What's the part number on IC1101 on the underside of the main board?
          Willing to help but I'm no expert.

          Comment


            #6
            Re: Sharp LC-60E79U problems

            What is the DCV on the PNL-PWR command pin/
            What do you get on PNL-12V if that power cable to the T-CON is connected?
            Switched MOSFET Q7120 provides the switched PNL-12V.
            http://www.shopjimmy.com/sharp-rdenc...pply-unit.htm#
            Sharp RDENCA369WJQZ (DPS-343AP A, 2950244303) Power Supply Unit
            Pictures provided by shopjimmy.
            Attached Files
            Last edited by budm; 07-19-2017, 01:29 PM.
            Never stop learning
            Basic LCD TV and Monitor troubleshooting guides.
            http://www.badcaps.net/forum/showthr...956#post305956

            Voltage Regulator (LDO) testing:
            http://www.badcaps.net/forum/showthr...999#post300999

            Inverter testing using old CFL:
            http://www.badcaps.net/forum/showthr...er+testing+cfl

            Tear down pictures : Hit the ">" Show Albums and stories" on the left side
            http://s807.photobucket.com/user/budm/library/

            TV Factory reset codes listing:
            http://www.badcaps.net/forum/showthread.php?t=24809

            Comment


              #7
              Re: Sharp LC-60E79U problems

              Attaintedragon, the voltage does not change when disconnected tcon from main (lvds)

              Dick, C18 lt bux is on IC1101

              Bud, the DCV on PNL-PWR was .8 then dropped when the power board clicked and shut down, when I did the hold vol down and input start up, it reads a steady 3.2v. I only get .7v on the 2 PNL-12v pins going to TCON

              thank you guys for all your help

              Comment


                #8
                Re: Sharp LC-60E79U problems

                Where is the MOSFET q7120 located? Is there a way to test if its functioning correctly?

                Comment


                  #9
                  Re: Sharp LC-60E79U problems

                  It is mounted on the heat sink. So did test the pnl-12V without the cable going to the T-CON board?
                  Never stop learning
                  Basic LCD TV and Monitor troubleshooting guides.
                  http://www.badcaps.net/forum/showthr...956#post305956

                  Voltage Regulator (LDO) testing:
                  http://www.badcaps.net/forum/showthr...999#post300999

                  Inverter testing using old CFL:
                  http://www.badcaps.net/forum/showthr...er+testing+cfl

                  Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                  http://s807.photobucket.com/user/budm/library/

                  TV Factory reset codes listing:
                  http://www.badcaps.net/forum/showthread.php?t=24809

                  Comment


                    #10
                    Re: Sharp LC-60E79U problems

                    when testing the pnl-12v, (in the force start up mode which lights all the backlights) it reads .7v, I can unplug that cable at the TCON board and voltage drops to zero

                    Comment


                      #11
                      Re: Sharp LC-60E79U problems

                      I cannot see how it drops to 0V on the PNL-12V pin unless there is no Voltage coming out from the PNL-12V.
                      At this point you need to report the Voltage reading on all 3 pin of the MOSFET when TV is off and when the TV is switched on.
                      Never stop learning
                      Basic LCD TV and Monitor troubleshooting guides.
                      http://www.badcaps.net/forum/showthr...956#post305956

                      Voltage Regulator (LDO) testing:
                      http://www.badcaps.net/forum/showthr...999#post300999

                      Inverter testing using old CFL:
                      http://www.badcaps.net/forum/showthr...er+testing+cfl

                      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                      http://s807.photobucket.com/user/budm/library/

                      TV Factory reset codes listing:
                      http://www.badcaps.net/forum/showthread.php?t=24809

                      Comment


                        #12
                        Re: Sharp LC-60E79U problems

                        Just to clarify that was with me testing the pin on the power supply board then unplugging that cable on the tcon side

                        Sorry for my lack of knowledge I'm slowly learning more but can you please inform me of where to check the Mosfet 3 pins I'm attaching a picture of the psb
                        Attached Files

                        Comment


                          #13
                          Re: Sharp LC-60E79U problems

                          All the Mosfet that start with q are on the primary side of the board, none of which are q7120 the 2 in the picture I'm attaching are q7602 and q7601
                          Attached Files

                          Comment


                            #14
                            Re: Sharp LC-60E79U problems

                            https://www.badcaps.net/forum/attach...9&d=1500513935
                            Left heatsink just above bottom left edge of the board, it is in the cold side of the circuit due to fact that it provides 12V for the T-CON.
                            Last edited by budm; 07-19-2017, 08:38 PM.
                            Never stop learning
                            Basic LCD TV and Monitor troubleshooting guides.
                            http://www.badcaps.net/forum/showthr...956#post305956

                            Voltage Regulator (LDO) testing:
                            http://www.badcaps.net/forum/showthr...999#post300999

                            Inverter testing using old CFL:
                            http://www.badcaps.net/forum/showthr...er+testing+cfl

                            Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                            http://s807.photobucket.com/user/budm/library/

                            TV Factory reset codes listing:
                            http://www.badcaps.net/forum/showthread.php?t=24809

                            Comment


                              #15
                              Re: Sharp LC-60E79U problems

                              can you zoom in on the picture I posted and give me the q number of the one you are referring to? Thanks

                              Comment


                                #16
                                Re: Sharp LC-60E79U problems

                                Do you see R7305, R7304, C7120?
                                Never stop learning
                                Basic LCD TV and Monitor troubleshooting guides.
                                http://www.badcaps.net/forum/showthr...956#post305956

                                Voltage Regulator (LDO) testing:
                                http://www.badcaps.net/forum/showthr...999#post300999

                                Inverter testing using old CFL:
                                http://www.badcaps.net/forum/showthr...er+testing+cfl

                                Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                                http://s807.photobucket.com/user/budm/library/

                                TV Factory reset codes listing:
                                http://www.badcaps.net/forum/showthread.php?t=24809

                                Comment


                                  #17
                                  Re: Sharp LC-60E79U problems

                                  Bud if I'm correct there are multiple mosfets I regret to inform you I'm not sure which one you want me to test

                                  Comment


                                    #18
                                    Re: Sharp LC-60E79U problems

                                    Look for those resistors and cap and you will see Q7120, I do not have the time to start the paint program to edit the picture right now.
                                    Never stop learning
                                    Basic LCD TV and Monitor troubleshooting guides.
                                    http://www.badcaps.net/forum/showthr...956#post305956

                                    Voltage Regulator (LDO) testing:
                                    http://www.badcaps.net/forum/showthr...999#post300999

                                    Inverter testing using old CFL:
                                    http://www.badcaps.net/forum/showthr...er+testing+cfl

                                    Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                                    http://s807.photobucket.com/user/budm/library/

                                    TV Factory reset codes listing:
                                    http://www.badcaps.net/forum/showthread.php?t=24809

                                    Comment


                                      #19
                                      Re: Sharp LC-60E79U problems

                                      yes I see them, the R almost look like diodes and the C7120 is a cap all on the secondary side

                                      Comment


                                        #20
                                        Re: Sharp LC-60E79U problems

                                        found it thanks to your tips, Ill test with power off and while powering on Thanks again

                                        Comment

                                        Working...
                                        X