MSI GS75 Stealth 10SFS Bios chip missing resistors...

[ethics]

I am missing 3x capacitors on this very damaged board and was wondering if anyone would know their values?
Could 3.3k work?
They are for CS pin 1 and DO (IO1) pin 2

Thanks in advance

[ethics]

Also I got the bios chip back and ran jumper wires but I think without the resistors to pull cs low it won't run firmware from bios?
Can anyone assist?

Thank you.

[mcplslg123]

Try with 33 ohms resistors.

[ethics]

Ok will try 33 ohms
adding another photo before it was destroyed=)
Can you please mark up best way to add missing resistors.

Thank you.

[ethics]

mon2, can you please help a fellow Canuck? =)
Thank you

[mcplslg123]

The resistor pads seems intact ,so you can easily solder the resistor there and run a jumper wire from pin1 of bios chip to the missing resistor.

[ethics]

please see TOP photo as bottom photo was previous state- TOP photo is more accurate as to what state board is in now-

thank you.

[ethics]

Can you please mark up photo as to what is what?
I am confused with adding in 2 resistors as I need to run jump wires from ENE chip-1 wire from CS# to a resistor-->pin 1 of bios chip and 1 wire from ENE spi output to resistor--> pin 2 bios chip?

Thank you.