Lenovo Legion 5 Pro - NM-D601 REV1.0 Turns off with battery conected

[judamex]

pin15 rises to 3.3V when battery is dosconnected?
Pin19 & 20 should read same voltage.

Yes, pin 15 goes up to 3V when I only connect the charger, it's in the table in post #19.
pins 19 and 20 usually have the same voltage, it can also be seen in the tables I shared

[judamex]

pin15 rises to 3.3V when battery is dosconnected?
Pin19 & 20 should read same voltage.

Yes, pin 15 goes up to 3V when I only connect the charger, it's in the table in post #19.
pins 19 and 20 usually have the same voltage, it can also be seen in the tables I shared

[mon2]

Please review your test results again.

If the battery IS connected, pin 15 should be close to 0 volts.
If the battery IS NOT connected, then pin 15 should be 3v3.

Do have the adapter connected as well.

Can you confirm this?

[judamex]

Please review your test results again.

If the battery IS connected, pin 15 should be close to 0 volts.
If the battery IS NOT connected, then pin 15 should be 3v3.

Do have the adapter connected as well.

Can you confirm this?

I checked the mosfets again and the result remained in Ohms,

I checked Pin#15 with battery it measures about 0.3
Pin#15 and without battery it reaches 2.93

When I repositioned the PQ5404 and PQ5406 mosfet, a symptom was added that I had not noticed, when I connect the charger together with the battery it turns on by itself.

[judamex]

Please review your test results again.

If the battery IS connected, pin 15 should be close to 0 volts.
If the battery IS NOT connected, then pin 15 should be 3v3.

Do have the adapter connected as well.

Can you confirm this?

I rectified the voltages and again everything is as in the tables. Tomorrow I will monitor the behavior of each pin with the oscilloscope. I will upload any news.