HP Mini 210 Hank Logo

[servis jaya.comp]

Salam All Master..
I Have problem HP Mini 210 Code NM6 Rev E..display hank on Logo HP and can't Boot to any devices..only hank on HP Logo.

-Chip LAN,SoundCard,Card REader,HDD removed and Flash Bios still not good result...

please help me what step i must ceck again...?
thanks..

[kropotkin]

Re: HP Mini 210 Hank Logo

Hi. Check also resistance at all USB_DATA lines to GND, it can easily be dead USB controller inside Intel NM10. It may became abnormally hot if broken.

[servis jaya.comp]

Re: HP Mini 210 Hank Logo

Hi. Check also resistance at all USB_DATA lines to GND, it can easily be dead USB controller inside Intel NM10. It may became abnormally hot if broken.

OK..Thanks for yout help and solution..i will try it..

how many resistance on USB_DATA pin to GND...?normally..thanks..

[kropotkin]

Re: HP Mini 210 Hank Logo

They all should be the same Compare to other alive boards. NM10 heats a lot normally at work, but after breaking it heats may be with spot a little bit more. Better to know POST-code, and name of motherboard, of course