Announcement
Collapse
No announcement yet.
Remove_SMM... UEFI.
Collapse
X
-
Re: Remove_SMM... UEFI.
Originally posted by siddiq View PostHello, I've tried patching a Lenovo X1 Carbon Gen 6 to no avail. I'm always getting an 8 beep error code and a blank screen. I want to know if its just about replacing the modules or additional steps have to be taken. I had an earlier X1 Gen 6 patched successfully in this forum (thank you dani981).But when I use that bios file, it gets to where I press F1 to enter setup and then it writes "entering setup..." and then nothing happens. I extracted the modules from the earlier patched bios and used them to patch this current X1, but all I get is 8 beeps. I want to know if UEFI Tools alone is enough. I will be grateful if this file will be patched for me. Thanks in advance.Attached Files
Comment
-
Re: Remove_SMM... UEFI.
Originally posted by poorrkkyy View PostHi any chance someone can unlock the dump attached for my X250?Attached Files
Comment
-
Supervisor password on X250
Hello everyone,
I've purchased a second-hand X250, without even imagining that the bios was locked, and of course the seller doesn't know the supervisor password.
After a few hours of searching, I stumbled upon this thread, and ordered the USB programmer to try and fix it.
I've tried to use the dump from aliencillo, but the laptop beeps 5 times x2, and shut down, nothing shows on the screen.
I've tried to understand what to do with UEFI tool, but I must admit I'm quite lost. Would there be someone nice enough to explain the process to me, or patch my image directly? That would be wonderful.
Here's the original image: https://drive.google.com/file/d/10Jc...ew?usp=sharing
Thanks in advance, have a good day
Comment
-
Re: Supervisor password on X250
Originally posted by tartinesKiller View PostHello everyone,
I've purchased a second-hand X250, without even imagining that the bios was locked, and of course the seller doesn't know the supervisor password.
After a few hours of searching, I stumbled upon this thread, and ordered the USB programmer to try and fix it.
I've tried to use the dump from aliencillo, but the laptop beeps 5 times x2, and shut down, nothing shows on the screen.
I've tried to understand what to do with UEFI tool, but I must admit I'm quite lost. Would there be someone nice enough to explain the process to me, or patch my image directly? That would be wonderful.
Here's the original image: https://drive.google.com/file/d/10Jc...ew?usp=sharing
Thanks in advance, have a good dayLast edited by SMDFlea; 04-01-2023, 07:27 AM.
Comment
-
Re: Remove_SMM... UEFI.
T470 Bios
I've tried patching the bios my self for my T470, Unfortunately I've not had any luck.
Main battery and CMOS battery disconnected. Tried pushing each of the three switches on the bottom and nothing. No musical beeps etc. Board starts, Screen flashes quickly, caps lock light blinks and then powers off.
Could anyone kindly take a look at the attached bios (clean dump before I did anything) and maybe patch it for me? Thanks!Last edited by SMDFlea; 04-01-2023, 07:27 AM.
Comment
-
Re: Supervisor password on X250
I finally managed to get an image working! I extracted LenovoTranslateService, BootOption and SystemPpisNeededByDxeCore from the X250 patched image provided by Maxpower3 here, as it wasn't working on my machine. I then patched my original image, and finally it accepted an arbitrary key. I then restored the original bios image, and the supervisor password was gone.
Thanks dani981 and to everyone who contributed to this thread, it really helped me.
Comment
Comment