La-e541p

[mahmoodjavan]

LA-E541P schematic plz

[mahmoodjavan]

Re: La-e541p

plz plz plz ...

[anshad]

Re: La-e541p

As far as i know, this schematic has not yet publicly available.

[joby91]

Re: Lenovo 320S-14

Hello together,

does anyone have schematic for this Laptop/Mainboard?

[SMDFlea]

Re: Lenovo 320S-14

Hello together,

does anyone have schematic for this Laptop/Mainboard?

EDIT. Its available on some paid sites .

[imranromi]

Re: Lenovo 320S-14

EDIT. Its available on some paid sites .

Where is have links?

[joby91]

Re: La-e541p

I have bought the schematics right now. i should recieve email with the pdf until tommorow and i will upload it here

[joby91]

Re: La-e541p

Here are the schematics for la-e541p

[SMDFlea]

Re: La-e541p

Thanks for being so generous

[sebulica]

Re: La-e541p

Thanks,man !

[CeeEee4]

Re: La-e541p

Thank you for sharing sir.

[krmpotic]

Re: La-e541p

Thank you

[Arielc72]

Re: La-e541p

Here are the schematics for la-e541p

Thanks a lot!!!

[luisfm2]

Re: La-e541p

Thank youuuuuuu.
I will see that what is this BAA70L (PU801).
It is in short circuit

[joshAU]

Re: La-e541p

Thank you!
Much appreciated!

[jikonik]

Re: La-e541p

thank you m8!!

[luisfelipezz2]

Re: La-e541p

thank youuuu

[tocha]

Re: La-e541p

Tnks

[mferna14]

Lenovo IdeaPad FLEX 5-1570 81CA totally dead

Hi, Does anyone have the boardview for Lenovo IdeaPad FLEX 5-1570 81CA LA-E541P. Schematics is posted but I need little help finding the components. The motherboard in this is CIUYA/SA/SB/SD LA-E541P. I am not getting max voltage on pin 1 of this chip PU703 ISL88739HRZ, getting only 2.254, is this voltage correct for the chip to operate??? Before this there is a resistor PR729 392K, I want the location of this resistor. Any help will be greatly appreciated. Thanks

[mferna14]

Re: La-e541p

I found the resistor & across this, on both ends I am getting 2.25 volt & on the other end it 19V which is correct. The resistor value is correct 392K. The N-Channel MOSFET PQ740, Drain I am getting 19 volts & on the Gate there should be a high voltage but here the volts fluctuates from .25 to .75, bouncing up & down & zero volts on source. Here I should get nearly 24 volts. Any tips will be a great help.