Announcement

Collapse
No announcement yet.

Norstar - Plus modular ICS NT7B62FA power supply repair

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Norstar - Plus modular ICS NT7B62FA power supply repair

    Patient: Norstar - Plus modular ICS NT7B62FA power supply.
    Complaint: Doesn't power up anymore. It did work for a short while, next morning dead?

    U1 (UC2844) Vcc pin jumping up and down between 10V and 15V. Vcc supply resistor 51.1k and capacitor 100uf 40V is o.k., but jet there is nothing coming out on the other end. Secondary is producing nothing, no shorts, nothing visible.

    Replaced U1 (UC2844) with a new one, powered the PSU up on the bench and the LED started to blink faintly. Plugged the PSU card back into the Norstar modular ICS and all is working fine as kind.

    A nice easy Saturday evening repair job. Can't get much easier than that!
    Attached Files

    #2
    Nice repair

    Did you replace any capacitors
    9 PC LCD Monitor
    6 LCD Flat Screen TV
    30 Desk Top Switching Power Supply
    10 Battery Charger Switching Power Supply for Power Tool
    6 18v Lithium Battery Power Boards for Tool Battery Packs
    1 XBox 360 Switching Power Supply and M Board
    25 Servo Drives 220/460 3 Phase
    6 De-soldering Station Switching Power Supply 1 Power Supply
    1 Dell Mother Board
    15 Computer Power Supply
    1 HP Printer Supply & Control Board * lighting finished it *

    These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
    1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
    2 Hem Saw Computer Stack Board
    All of these had CAPs POOF
    All of the mosfet that are taken out by bad caps

    Comment


      #3
      Originally posted by sam_sam_sam View Post
      Nice repair

      Did you replace any capacitors
      No, I didn't replace any capacitors, but I did check them on my ESR tester perfectly fine.

      Comment

      Working...
      X