yours MB build in ONE Soc if the Soc section GPIO " General-purpose Input/Output "faced issue by BGA at contact pins or the section self defect at Soc . to narrow the issue... disconnect the LVDS from T-CON side and fed t-con at the point 12V_in with 12V from PSU
Announcement
Collapse
No announcement yet.
Pioneer PN50951-22U Backlight On, No Image
Collapse
X
-
Originally posted by Diah View Postyours MB build in ONE Soc if the Soc section GPIO " General-purpose Input/Output "faced issue by BGA at contact pins or the section self defect at Soc . to narrow the issue... disconnect the LVDS from T-CON side and fed t-con at the point 12V_in with 12V from PSU
Do you mean use a wire to borrow 12v from the psu and apply it to the 12v of the TCON? What would I be looking for after I do this?
Comment
-
Originally posted by Diah View Post
yes. you will have probably RGB test pattern on the LCD
I removed and reconnected all of the ribbons and cables previously with no affect. Not sure what made the difference this time, but it's working! I'll report back after I get a remote and play around with it for a while.
Thanks for the help guys!
Comment
-
I ordered a control and received it yesterday hoping to complete the setup and start testing the TV. The control I bought is IR only so when I get to the part in setup for pairing a remote I can't pair it. Without a Bluetooth remote this tv cannot do anything after it is factory reset. After setup is completed apparently an IR remote will work fine 🤦
I ordered another one with Bluetooth that should come tomorrow. I will test it out and report back. As this appears to have been a firmware bug of some sort I hope it doesn't resurface again.
Comment
Comment